Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.41

Water pressure too high

Information: nothing to do

The water pressure in the heating system is too high: above 2.8 bar on the models that give a threshold (6 bar on the Thema Condens F AS 80). This is a warning, not a fault code: the boiler display can show the current pressure and the minimum and maximum pressures.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Read the water pressure on the boiler display and give us the value.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.41

The meaning depends on the boiler: find yours below.

S.041

The water pressure in the heating system is too high

Information: nothing to do Isotwin Condens CS/1, Thema Condens CS/1
S.41

The system pressure is too high

Information: nothing to do Isotwin Condens, Thema Condens
S.41

Water pressure too high

Information: nothing to do Isotwin Condens F, Thema Condens AS 48/65, Thema Condens F, Thermomaster, Thermomaster F
S.41

Water pressure > 2.8 bar

Information: nothing to do Thema Condens F AS 45/65, ThemaClassic C30, Thematek C 18/24-LC/1
S.41

Water pressure > 0.6 MPa (6 bar)

Information: nothing to do Thema Condens F AS 80

The boilers that show this code

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.