Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.32

Waiting: fan speed out of tolerance

Information: nothing to do

The fan speed is too far from the expected value: the boiler waits, then restarts the fan by itself. This is a waiting time, not a fault code: the boiler tries again on its own.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.32

The meaning depends on the boiler: find yours below.

S.032

The fan restarts due to an excessive speed deviation

Information: nothing to do Isotwin Condens CS/1, Thema Condens CS/1
S.32

The fan start-up waiting time is activated

Information: nothing to do Isotwin Condens, Thema Condens
S.32

Check cycle: fan speed during operation out of tolerance

Information: nothing to do Isotwin Condens F, Thema Condens F
S.32

Heat exchanger frost protection active, as the speed fault of…

Information: nothing to do Thema Condens F AS 45/65
S.32

Waiting mode due to fan speed deviation

Information: nothing to do Thema Condens AS 48/65, Thema Condens F AS 80
S.32

Fan waiting period: fan speed out of tolerance

Information: nothing to do Thermomaster
S.32

Fan waiting: fan speed out of tolerance

Information: nothing to do Thermomaster F

The boilers that show this code

What our technician checks

  • The fan and its speed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.