Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.28

Hot water cylinder: burner off-time

Information: nothing to do

After heating the hot water, the burner waits for an off-time to end before it can light again. This is a normal operating message: there is nothing to do.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.28

The meaning depends on the boiler: find yours below.

S.028

Domestic hot water cylinder charging is active and the appliance is in the phase of…

Information: nothing to do Isotwin Condens CS/1, Thema Condens CS/1
S.28

Burner off time in domestic hot water mode is activated

Information: nothing to do Isotwin Condens, Thema Condens
S.28

The boiler blocks the heat exchanger temperature rise after a heating cycle

Information: nothing to do Thema Condens F
S.28

The boiler blocks reheating of the cylinder after a heat-up cycle

Information: nothing to do Isotwin Condens F
S.28

Burner delay for hot water

Information: nothing to do Thema Condens F AS 45/65
S.28

Domestic hot water mode, burner anti-cycling time

Information: nothing to do Thema Condens F AS 80
S.28

Hot water: burner anti-cycling time

Information: nothing to do Thema Condens AS 48/65, ThemaClassic C30
S.28

Domestic hot water mode: temporary burner shutdown

Information: nothing to do Thermomaster
S.28

Cycle time

Information: nothing to do Thermomaster F
S.28

Cylinder mode: domestic hot water burner anti-cycling time

Information: nothing to do Thematek C 18/24-LC/1

The boilers that show this code

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.