Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bulex Fault code Bulex
F.83

Temperature does not rise at burner start

Breakdown: the boiler is stopped

When the burner starts, the flow and return sensors see no temperature rise, or too slow a rise: lack of water or pressure too low in the heating, or a sensor not touching its pipe properly. This is a fault: the boiler stops and our technician has to find the cause before putting it back into service.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Look at the heating water pressure on the display: if it is too low, top it up as the boiler's user manual explains.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.83?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.83

The meaning depends on the boiler: find yours below.

F.083

The temperature rise recorded by the flow temperature sensor or the…

Breakdown: the boiler is stopped Isotwin Condens CS/1, Thema Condens CS/1
F.83

NTC temperature variation fault

Breakdown: the boiler is stopped Isotwin Condens, Thema Condens
F.83

Temperature change fault of the flow and/or return temperature sensor

Breakdown: the boiler is stopped Thema Condens AS 48/65, Thema Condens F AS 80, ThemaClassic C30
F.83

Fault: dry running

Breakdown: the boiler is stopped Thermomaster
F.83

Temperature variation fault of the flow temperature sensor and/or the…

Breakdown: the boiler is stopped Thematek C 18/24-LC/1
F83

No water in the installation: no temperature rise even though the burner is lit

Breakdown: the boiler is stopped Isotwin Condens F, Thema Condens F

The boilers that show this code

What our technician checks

  • The system pressure and water quantity, topped up if needed
  • The flow sensor, properly placed on the flow pipe
  • The return sensor, properly placed on the return pipe
  • Sensor operation and connections
  • Leaks in the boiler and the system
  • The pump connections

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.