Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bulex Fault code Bulex
F.00

Flow temperature sensor disconnected

Breakdown: the boiler is stopped

The boiler no longer receives the signal from its flow temperature sensor, which measures the water sent to the heating: the sensor, its cable or a connector is at fault. It is a fault code that needs a technician; the one exception is the ThermoMaster HR TOP, where F0 means "no fault".

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.00?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.00

The meaning depends on the boiler: find yours below.

F.0

Flow temperature sensor open circuit

Breakdown: the boiler is stopped Thema Condens F AS 45/65
F.00

Flow sensor open circuit

Breakdown: the boiler is stopped Isotwin Condens, Thema Condens
F.00

Flow temperature sensor open circuit

Breakdown: the boiler is stopped Thema Condens AS 48/65, Thema Condens F AS 80, ThemaClassic C30, Thematek C 18/24-LC/1
F.00

Fault: flow temperature sensor

Breakdown: the boiler is stopped Thermomaster
F.000

The flow temperature sensor signal is interrupted

Breakdown: the boiler is stopped Isotwin Condens CS/1, Thema Condens CS/1
F0

no fault

Information: nothing to do Thermomaster HR TOP
F00

Faulty temperature sensor in the heating flow pipe

Breakdown: the boiler is stopped Isotwin Condens F, Thema Condens F

The boilers that show this code

What our technician checks

  • The flow temperature sensor's connector and cable
  • The flow temperature sensor, replaced if needed
  • The multi-pin connector on the circuit board
  • The wiring harness, for a break
  • The circuit board

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.