Water pressure sensor: signal too low
Breakdown: the boiler is stopped
The water pressure sensor sends a signal that is too low or no signal at all: sensor, cable or plug broken or short-circuited; on the 2015 Thema Condens and IsoTwin Condens it can also report a water pressure that is too low. This is a fault: the boiler stops and our technician has to find the cause before putting it back into service.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.73?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.73
The meaning depends on the boiler: find yours below.
The water pressure sensor is short-circuited
Water pressure sensor fault (signal too low)
Water pressure sensor fault
Water pressure sensor signal in an unsuitable range (pressure too…
Fault: water pressure sensor not connected or short-circuited
Faulty pressure sensor in the heating circuit
The boilers that show this code
What our technician checks
- The system water pressure
- The sensor wiring harness, plug and earth connection (break, short circuit)
- The water pressure sensor, replaced if faulty