Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bulex Fault code Bulex
F.29

Flame lost during operation, relighting failed

Breakdown: the boiler is stopped

The flame went out while the boiler was heating and the relighting attempts failed, for example the gas was cut off for a moment, flue gas recirculating to the air intake, a blocked condensate drain or a poor earth: the boiler goes into fault mode and stops heating. The one exception is the older Thema Condens F 24/30, where F29 points to the heat exchanger's thermal fuse.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the boiler's gas tap is open.
  3. Code without a dot on a Thema Condens F 24/30: do not reset, call us.
  4. Reset the boiler once only.
  5. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F.29?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.29

The meaning depends on the boiler: find yours below.

F.029

The ignition attempt after flame loss during operation failed

Breakdown: the boiler is stopped Isotwin Condens CS/1, Thema Condens CS/1
F.29

Operating fault: ignition failed

Breakdown: the boiler is stopped Isotwin Condens, Thema Condens
F.29

Failure during operation: re-ignition unsuccessful

Breakdown: the boiler is stopped Thema Condens F AS 45/65
F.29

Fault during operation: re-ignition failed

Breakdown: the boiler is stopped Thema Condens F AS 80
F.29

Ignition and monitoring fault during operation - flame loss

Breakdown: the boiler is stopped Thema Condens AS 48/65, ThemaClassic C30, Thematek C 18/24-LC/1
F.29

Fault: flame loss

Breakdown: the boiler is stopped Thermomaster
F29

Flame goes out during operation

Breakdown: the boiler is stopped Isotwin Condens F, Thema Condens F
F29

Thermal fuse fault

Breakdown: the boiler is stopped Thema Condens F 24/30

The boilers that show this code

What our technician checks

  • The gas supply
  • The flue: recirculation or blockage
  • The condensate drain
  • The appliance earth
  • The ignition transformer and the igniter
  • The control electrode (gap to the burner, corrosion)
  • The gas valve and the air-gas ratio
  • Thema Condens F 24/30: the heat exchanger, to be replaced

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.