Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Viessmann Fault code Viessmann
F7

Pressure or hot water sensor fault

Blocking: it retries by itself

On a Vitodens 300-W B3HA or 100-W WB1A the water pressure sensor is faulty (short or open circuit), and on a Vitodens 200 WB2A it is the air pressure switch: the burner blocks and the boiler stops heating until the part is repaired. On a Vitodens One Base (200-W B2HF or B2KF, 222-F B2TF, 222-W B2LF), F.7 means the hot water temperature sensor is open-circuited: the boiler no longer makes domestic hot water.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F7?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F7

The meaning depends on the boiler: find yours below.

F.7

Open circuit of the DHW temperature sensor

Blocking: it retries by itself Vitodens One Base
F7

Short circuit or open circuit of the water pressure sensor

Blocking: it retries by itself Vitodens 300-W B3HA
F7

Water pressure sensor faulty

Blocking: it retries by itself Vitodens 100-W WB1A
F7

Air pressure switch faulty

Blocking: it retries by itself Vitodens 200 WB2A

What our technician checks

  • The water pressure sensor and its connecting cable (Vitodens 300-W B3HA, 100-W WB1A)
  • The air pressure switch and its connecting cable (Vitodens 200 WB2A)
  • Vitodens One Base: the « Hot water » setting in the commissioning assistant
  • Vitodens One Base: the hot water sensor connection (plug 5, terminals 3 and 4 on the HMU electronics module): plug, wires, corrosion, cables
  • Vitodens One Base: the sensor's resistance (NTC 10 kΩ) compared with the curve, sensor replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.