Flue gas temperature too high
Breakdown: the boiler is stopped
The boiler's flue gas has gone above its maximum temperature and the flue gas temperature limiter has cut the burner: our technician checks the water level, air in the system, the circulation pump and the flue. The boiler locks out: it only starts again after a reset, once the flue has cooled down.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Look at the water pressure on the boiler's pressure gauge: below 1 bar (0.8 bar on a Vitodens 100-W) it is too low. Top up only if your installer has shown you how; otherwise, call us.
- Do not reset the boiler: call us.
Does your boiler show F1?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F1
The meaning depends on the boiler: find yours below.
Maximum flue gas temperature exceeded
The flue gas temperature limiter has tripped
The flue gas temperature limiter has responded
What our technician checks
- The fill level of the heating system
- Bleeding the air out of the system
- The circulation pump (Vitodens 100-W B1HC, B1HA, WB1C)
- The flue (Vitodens 100-W WB1B)
- The reset, once the flue has cooled down