Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Viessmann Fault code Viessmann
E9

Flame loss or abnormal flame signal during calibration

Breakdown: the boiler is stopped

On a Vitodens 200-W B2HB, 222-F B2TB or B2SB and 222-W B2LB, the flame went out several times during the automatic calibration of the combustion; on a Vitodens 200-W WB2B, 222-F FS2A or 222-W WS2A, the flame signal (ionisation current) went outside the allowed range during that calibration. In both cases the burner goes into fault: the boiler stops heating and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.
  4. Keep paint, solvent and cleaning product fumes, and building dust, away from the boiler.

Does your boiler show E9?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code E9

The meaning depends on the boiler: find yours below.

E9

Repeated loss of flame during calibration

Breakdown: the boiler is stopped Vitodens 200-W B2HB, Vitodens 222-F B2SB, Vitodens 222-F B2TB, Vitodens 222-W B2LB
E9

Ionisation current outside the valid range during calibration

Breakdown: the boiler is stopped Vitodens 200-W WB2B, Vitodens 222-F FS2A, Vitodens 222-W WS2A

What our technician checks

  • The ionisation electrode and its connecting cable
  • The plug connections (loose contacts)
  • The flue system: tightness and flue gas recirculation
  • Condensate build-up in the system (remove the fan unit before the burner)
  • The inlet of the combined gas valve and its strainer (fouling)
  • The source of deposits on the electrodes in the boiler room and flue system (detergents, cleaning or personal care products)
  • After replacing the burner grid and the electrode: cleaning the fan unit, the gas-air duct and the Venturi extension

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.