Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Viessmann Fault code Viessmann
E2

No calibration, water flow too low

Breakdown: the boiler is stopped

The boiler could not carry out the automatic calibration of its combustion, because too little water was flowing and its heat could not be passed on to the heating. The burner goes into fault: the boiler stops heating and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the thermostatic radiator valves are open, so that the boiler can pass on its heat.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show E2?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code E2

The meaning depends on the boiler: find yours below.

E2

No calibration because of too low flow rate

Breakdown: the boiler is stopped Vitodens 200-W B2HB, Vitodens 222-F B2SB, Vitodens 222-F B2TB, Vitodens 222-W B2LB, Vitodens 300-W B3HB
E2

No calibration because the flow rate is too low

Breakdown: the boiler is stopped Vitodens 300-W B3HA

What our technician checks

  • Heat take-off by the system during calibration (enough water flow)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.