Air in the pump or low water flow
Blocking: it retries by itself
On the Vitodens 200-W B2HB, 222-F (B2TB, B2SB, B2TA, B2SA, FR2B, FS2A), 222-W B2LB and 300-W (B3HB, B3HA), there is air in the internal circulation pump or the heating water is not flowing enough. The boiler blocks its burner and starts an air-venting programme by itself; if the code stays on, our technician must vent the installation.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Check the water pressure on the gauge: below 1.0 bar it is too low. Top up as your installer showed you, or call us.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show A8?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code A8
The meaning depends on the boiler: find yours below.
Air in the internal circulation pump or the minimum flow rate is not reached
What our technician checks
- Venting the installation, if the message stays on after the automatic venting programme
- The minimum water flow through the internal pump