CO alarm: carbon monoxide limit exceeded
Breakdown: the boiler is stopped
On the Vitodens 200-W B2HB, 222-F B2TB, 222-F B2SB and 222-W B2LB, the carbon monoxide (CO) detector connected to the boiler has detected a value above its limit: the burner is blocked and the alarm sounds, because CO can cause fatal poisoning; leave the room, air it and call us. On a Vitodens 100-W B1HF, this number only means that the Open-Therm remote control is not connected: the burner stays off until our technician restores the connection.
What you can do
- CO alarm (Vitodens 200-W B2HB, 222-F B2TB, 222-F B2SB, 222-W B2LB): switch the boiler off, air the room, close the doors to the living areas, get everyone out and call us. Do not reset the boiler.
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show 95?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code 95
The meaning depends on the boiler: find yours below.
CO limit value exceeded
Open-Therm remote control not connected
What our technician checks
- The cause of the high CO value, found and removed
- Silencing the alarm with the Test key of the CO detector, once the fault is cleared
- The connection of the Open-Therm remote control (Vitodens 100-W B1HF)
- Parameter C.7 in the commissioning assistant, set to a value other than 14 if Open-Therm is not wanted (Vitodens 100-W B1HF)