Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Viessmann Fault code Viessmann
74

Temperature limiter short to earth

Breakdown: the boiler is stopped

On a Vitodens 200-W B2HB, 222-F B2TB or B2SB, or 222-W B2LB, the temperature limiter, its cables or its plugs touch an earthed part (short to earth): the burner stops and may lock out, and the boiler then only starts again after a reset. On a Vitodens 100-W B1HF, code 74 reports a water pressure in the system that is too low: the burner and the pump stop, with no heating and no hot water, until the pressure is restored.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Vitodens 100-W B1HF: check the system pressure on the display. Below 1.0 bar, top up with water or call us.
  3. Code 74 on a Vitodens 100-W B1HF: the burner is not locked out, do not reset the boiler.
  4. Reset the boiler once only.
  5. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 74?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 74

The meaning depends on the boiler: find yours below.

74

Short circuit to earth of the temperature limiter

Breakdown: the boiler is stopped Vitodens 200-W B2HB, Vitodens 222-F B2SB, Vitodens 222-F B2TB
74

Short circuit to earth of the safety temperature limiter

Breakdown: the boiler is stopped Vitodens 222-W B2LB
74

System pressure too low

Blocking: it retries by itself Vitodens 100-W B1HF

What our technician checks

  • The temperature limiter, its cables and its plugs: no contact with an earthed part
  • The reset with the R key, once the contact is cleared
  • Topping up the water and venting the system (Vitodens 100-W B1HF)
  • The system pressure sensor, compared with an external gauge (Vitodens 100-W B1HF)
  • The expansion vessel pre-charge pressure (Vitodens 100-W B1HF)
  • The system pressure set point and its range (Vitodens 100-W B1HF)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.