Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
Su:2

Flow temperature rising too fast

Blocking: it retries by itself

The water leaving the boiler for the heating warms up faster than allowed, most often because too little water is flowing, sometimes because of a sensor. On the Calenta, Tzerra M and Quinta Pro it is a blocking code: the boiler stops and starts again by itself once the cause is gone (on the Tzerra M, the status light on the button flashes green once).

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the system water pressure: at least 0.8 bar. Too low? Top up with water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show Su:2?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code Su:2

The meaning depends on the boiler: find yours below.

Su:2

Maximum rise of the flow temperature exceeded

Blocking: it retries by itself Calenta, Quinta Pro, Tzerra M

The boilers that show this code

What our technician checks

  • Water circulation: direction, pump and valves
  • The system water pressure
  • Fouling of the heat exchanger
  • Operation and fitting of the sensors

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.