Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
d5

External flow temperature sensor faulty

Breakdown: the boiler is stopped

The external flow temperature sensor on the system's low loss header is faulty (break or short circuit); on the Cerapur ZWB-3, CerapurComfort ZWBR-3 and CerapurSmart this code also comes from a sensor that was unplugged and connected elsewhere after it had been detected. On a Cerapur ZWB-4 (D5 330, D5 331) it is a blocking fault: the boiler starts again by itself once the sensor works again; on the other models it stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Codes D5 330 or D5 331 on a Cerapur ZWB-4: the boiler restarts by itself once the fault has cleared, do not reset it.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show d5?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code d5

The small number shown beside the code tells which.

d5

External temperature limiter faulty. (low loss header) / The sensor of…

Breakdown: the boiler is stopped Cerapur ZWB-3, Cerapur ZWBR-3, CerapurSmart
d5
330

External flow temperature sensor faulty (low loss header)

Blocking: it retries by itself Cerapur ZWB-4
d5
331

External flow temperature sensor faulty (low loss header)

Blocking: it retries by itself Cerapur ZWB-4

The boilers that show this code

What our technician checks

  • The external temperature sensor and its cable (break, short circuit), replaced if needed
  • Only one external flow sensor connected, the second one removed if there are two
  • Resetting the Heatronic (function 8.E) and IPM 1 or IPM 2 to base settings, then the automatic system configuration with the thermostat

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.