Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
d3

External safety contact open

Breakdown: the boiler is stopped

A safety contact connected to the boiler is open: the external temperature limiter (TB 1, for example the one of an underfloor heating) has tripped, is faulty or locked, or the bridge on its terminals is missing; on a Cerapur ZWB-4 a failed condensate pump also gives this code. On a Cerapur ZWB-4 (D3 232) it is a blocking fault: the boiler starts again by itself once the contact closes; on the other models it stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Code D3 232 on a Cerapur ZWB-4: the boiler restarts by itself once the fault has cleared, do not reset it.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show d3?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code d3

The small number shown beside the code tells which.

d3

Temperature limiter TB 1 faulty / The external temperature limiter has cut out /…

Breakdown: the boiler is stopped Cerapur ZWB-3, Cerapur ZWBR-3, CerapurSmart
d3

Jumper 161 on terminal strip ST 8 has not been recognised

Breakdown: the boiler is stopped ZWC-3
d3

Jumper 8-9 not detected

Breakdown: the boiler is stopped Cerapur, Cerasmart
d3
232

The temperature controller TB 1 has tripped / Temperature controller TB 1…

Blocking: it retries by itself Cerapur ZWB-4

The boilers that show this code

What our technician checks

  • The external temperature limiter TB 1 and its setting, unlocked if it is locked
  • The temperature sensor and its cable (break, short circuit), replaced if needed
  • The bridge on the external contact terminals (8-9, or bridge 161 on ST 8 for the ZWC-3), and the plug firmly seated
  • The heating control setting (Cerapur ZWB-4)
  • The condensate drain and the condensate pump, replaced if needed (Cerapur ZWB-4)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.