Flame detected while the boiler is off
Breakdown: the boiler is stopped
The boiler detects a flame while its burner is off: a dirty or cracked electrode, moisture on the circuit board or the flue is at fault; on a Cerapur ZWB-4, F7 328 means something else, an interrupted mains voltage. It is a fault: the boiler stops and only starts again after a reset; F7 328, however, clears by itself once the power is back.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Code F7 328 on a Cerapur ZWB-4: the boiler restarts by itself once the fault has cleared, do not reset it.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show F7?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F7
The small number shown beside the code tells which.
Flame is detected while the boiler is out of operation
Although the burner is off, flame is detected
Mains voltage interrupted
The boilers that show this code
What our technician checks
- The electrode set: cracks, dirt, replaced if needed
- The flue, cleaned or improved if needed
- Moisture on the circuit board, dried if needed
- The electrode wiring (CeraclassExcellence ZWC-3)
- For F7 328: the mains voltage