Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bulex Fault code Bulex
F.03

Cylinder sensor or air supply fault

Breakdown: the boiler is stopped

On the dotted Bulex boilers (F.03, F.003) and on the IsoTwin Condens F (F03), the boiler no longer receives the signal from its hot water cylinder's temperature sensor. On the older Thema Condens F 24/30 and Isotwin (F3 without a dot), it is a repeated air fault, which stops the boiler; on an Isotwin/Isomax C, F3 is the chimney spillage safety: the boiler stops and restarts by itself after 15 minutes.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Smell of flue gas in the house? Open doors and windows wide, switch the boiler off and call us.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F.03?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.03

The meaning depends on the boiler: find yours below.

F.003

The storage temperature sensor signal is interrupted

Breakdown: the boiler is stopped Isotwin Condens CS/1, Thema Condens CS/1
F.03

Cylinder sensor open circuit

Breakdown: the boiler is stopped Isotwin Condens, Thema Condens
F.03

Open circuit at the storage temperature sensor

Breakdown: the boiler is stopped Thema Condens AS 48/65, ThemaClassic C30
F.03

Storage temperature sensor open circuit

Breakdown: the boiler is stopped Thematek C 18/24-LC/1
F03

Cylinder temperature sensor fault

Breakdown: the boiler is stopped Isotwin Condens F
F3

Repeated air fault

Breakdown: the boiler is stopped Isotwin, Thema Condens F 24/30
F3

Chimney spillage safety device on C models

Blocking: it retries by itself Isotwin-Isomax

The boilers that show this code

What our technician checks

  • Dotted-code boilers: the cylinder sensor, replaced if needed
  • Dotted-code boilers: the sensor connector and its connection
  • Dotted-code boilers: the link to the cylinder electronics
  • Older boilers: the causes of fault F2 (air supply, flue, pressure switch, fan)
  • Isotwin/Isomax C: the chimney flue, even partly blocked

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.