Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
ACV Fault code ACV
E30

Flow sensor shorted or temperature difference too high

Breakdown: the boiler is stopped

On a Prestige MkIII or a HeatMaster 25 C with the ESYS controller, and on a recent Prestige or HeatMaster with the ACVMax screen (Evo included), E30 means a short circuit of the flow temperature sensor (NTC1 on ESYS); on a Prestige MkII or a HeatMaster TC from before 2015 (MCBA controller), it means too large a difference between the flow (T1) and return (T2) temperatures, which calls for a check of the water flow. In every case the boiler locks out and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model, without opening the appliance.
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show E30?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code E30

The meaning depends on the boiler: find yours below.

E30

Maximum temperature difference between T1 and T2 is too high

Breakdown: the boiler is stopped MCBA
E30

NTC1 short circuit

Breakdown: the boiler is stopped ESYS
E30

Flow sensor short circuit

Breakdown: the boiler is stopped ACVMax, ACVMax Touch

What our technician checks

  • The flow sensor, its connection and wiring: short circuit (ESYS, ACVMax)
  • The sensor or its wiring, replaced if needed (ESYS, ACVMax)
  • Restarting the boiler once the repair is done (ACVMax)
  • The water flow through the boiler (MCBA)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.