Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
ACV Fault code ACV
E07

Flue gas too hot or gas valve relay

Breakdown: the boiler is stopped

On a Prestige MkIII or a HeatMaster 25 C with the ESYS controller, and on a recent Prestige or HeatMaster with the ACVMax screen (Evo included), E07 means the flue gas is too hot; on a Prestige MkII or a HeatMaster TC from before 2015 (MCBA controller), it means a fault of the gas valve relay. With the ACVMax screen the boiler starts again by itself once the flue gas temperature is back to normal; with MCBA and ESYS it locks out and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model, without opening the appliance.
  2. ACVMax screen: the boiler restarts by itself once the flue gas has cooled down, do not reset it.
  3. Do not reset the boiler: call us.

Does your boiler show E07?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code E07

The meaning depends on the boiler: find yours below.

E07

Gas valve relay error

Breakdown: the boiler is stopped MCBA
E07

Flue gas temperature too high (NTC5)

Breakdown: the boiler is stopped ESYS
E07

Excessive flue gas temp.

Blocking: it retries by itself ACVMax, ACVMax Touch

What our technician checks

  • The NTC5 flue gas sensor, its connection and wiring, replaced if needed (ESYS)
  • The heat exchanger, cleaned if needed (ACVMax)
  • The MCBA board, to be replaced or reprogrammed if the fault persists after two resets (MCBA)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.