Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
ACV Fault code ACV
E11

Memory error or faulty sensor

Breakdown: the boiler is stopped

On a Prestige MkII or a HeatMaster TC from before 2015 (MCBA controller), E11 means an error in the controller's memory (EPROM); on a Prestige MkIII or a HeatMaster 25 C with the ESYS controller, it means that a temperature sensor, flow (NTC1) or return (NTC2), is faulty. In both cases the boiler locks out and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model, without opening the appliance.
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show E11?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code E11

The meaning depends on the boiler: find yours below.

E11

EPROM error

Breakdown: the boiler is stopped MCBA
E11

NTC1 or NTC2 sensor faulty

Breakdown: the boiler is stopped ESYS

What our technician checks

  • The MCBA board, replaced if the fault persists after two resets (MCBA)
  • The NTC1 and NTC2 sensors, replaced if needed (ESYS)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.