Flame too short at burner start (fault)
Breakdown: the boiler is stopped
On a WTC-GW C series boiler, a flame formed briefly when the burner started but was gone at the end of the safety time. This is a fault: the boiler locks out if it can no longer run safely, and the display then offers to unlock it.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show F21-2?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F21-2
The meaning depends on the boiler: find yours below.
Combustion manager: No flame formation when the burner starts
What our technician checks
- The gas supply pressure (flow monitor)
- The ionisation electrode, replaced if needed
- The burner surface, cleaned or replaced
- Clean combustion air, free of impurities
- Flame formation time, ignition settings and the gas valve calibration value
- Flue system tightness (room-sealed operation) and a clear flue path
- The condensate drain
- The isolating valves, replaced if needed