Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F21-1

No flame at burner start (fault)

Breakdown: the boiler is stopped

On a WTC-GW C series boiler, no flame formed when the burner started. This is a fault: the boiler locks out if it can no longer run safely, and the display then offers to unlock it.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F21-1?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F21-1

The meaning depends on the boiler: find yours below.

F21-1

Combustion manager: No flame formation when the burner starts

Breakdown: the boiler is stopped WTC-GW C (WEP)

What our technician checks

  • The gas supply pressure (flow monitor)
  • The ionisation electrode, replaced if needed
  • The burner surface, cleaned or replaced
  • Clean combustion air, free of impurities
  • The ignition device, replaced if needed
  • The gas valve block and its cable, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.