Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F11

Flow water above 105 °C

Breakdown: the boiler is stopped

The water leaving the boiler has gone above 105 °C at the safety thermostat: the fuel supply is cut, the pump keeps running and the boiler locks out. It is the protection against overheating and lack of water: the boiler only starts again after a reset, and our technician has to find the cause (lack of water, air or too little circulation).

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F11?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F11

The meaning depends on the boiler: find yours below.

F11

Flow sensor temp. > 105 °C

Breakdown: the boiler is stopped WTC-GW C (WEP), WTC-GW/GB B (WEM)
F11

Boiler temperature ≥ 105°C

Breakdown: the boiler is stopped Thermo Condens WTC-A (WCM)
F11

Temperature at flow sensor > 105 °C

Breakdown: the boiler is stopped WTC-OB (WCM-OB)

What our technician checks

  • The water flow through the boiler, increased if needed
  • The water circulation and the pump
  • The water fill of the system
  • Venting the water side
  • Dirt or scale in the heat exchanger on the water side

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.