Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F39

Sensor T2 or B11 faulty

Breakdown: the boiler is stopped

A sensor of equipment connected to the boiler is faulty: sensor T2 of an extension module on a WTC-GW or WTC-GB B series boiler, the bottom sensor (T2) of the buffer tank on a WTC-GW C series boiler, sensor B11 of the buffer tank or low loss header on a Thermo Condens WTC-A or a WTC-OB oil boiler. It is a fault: the boiler locks out if it can no longer run safely, and our technician has to check the sensor.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F39?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F39

The meaning depends on the boiler: find yours below.

F39

Add-on module sensor T2 faulty

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)
F39

Lower tank sensor (T2) faulty

Breakdown: the boiler is stopped WTC-GW C (WEP)
F39

Buffer tank sensor B11 faulty

Breakdown: the boiler is stopped Thermo Condens WTC-A (WCM)
F39

Buffer tank / low-loss header sensor (B 11) faulty

Breakdown: the boiler is stopped WTC-OB (WCM-OB)

What our technician checks

  • The sensor and its cable, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.