Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F38

Sensor T1 or B10 faulty

Breakdown: the boiler is stopped

A sensor of equipment connected to the boiler is faulty: sensor T1 of an extension module on a WTC-GW or WTC-GB B series boiler, the top sensor (T1) of the buffer tank on a WTC-GW C series boiler, buffer tank sensor B10 on a Thermo Condens WTC-A or a WTC-OB oil boiler. It is a fault: the boiler locks out if it can no longer run safely, and our technician has to check the sensor.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F38?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F38

The meaning depends on the boiler: find yours below.

F38

Add-on module sensor T1 faulty

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)
F38

Upper tank sensor (T1) faulty

Breakdown: the boiler is stopped WTC-GW C (WEP)
F38

Buffer tank sensor B10 faulty

Breakdown: the boiler is stopped Thermo Condens WTC-A (WCM)
F38

Buffer tank sensor (B10) faulty

Breakdown: the boiler is stopped WTC-OB (WCM-OB)

What our technician checks

  • The sensor and its cable, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.