Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
9x

Flame lost on stage 2

Breakdown: the boiler is stopped

On a two-stage WL10 or WL20 Z oil burner (W-FM 10 control box), the flame went out while running on stage 2: air leak or too much vacuum in the oil supply, dirty nozzle, burner setting or flame sensor. The burner is locked out (red light button) and does not restart by itself; you read this code by counting 9 red flashes after pressing the button for 5 seconds.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 9x?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 9x

The meaning depends on the boiler: find yours below.

9x

Flame loss during operation (stage 2)

Breakdown: the boiler is stopped W-FM 10

What our technician checks

  • The oil supply: air leak, too much suction vacuum
  • The nozzle, to be replaced
  • The burner setting and the flame sensor current
  • The flame sensor: cleaned, or replaced if faulty

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.