Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
4x

Flame detected outside operation

Breakdown: the boiler is stopped

On a WL5, WL10 or WL20 oil burner, the flame sensor sees a flame or light before or after the burner runs: stray light, a faulty sensor, or a leaking solenoid valve that lets a flame form during pre-purge. The burner is locked out (red light button) and does not restart by itself; you read this code by counting 4 red flashes after pressing the button for 5 seconds.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 4x?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 4x

The meaning depends on the boiler: find yours below.

4x

Flame simulation / extraneous light

Breakdown: the boiler is stopped W-FM 05, W-FM 10

The boilers that show this code

What our technician checks

  • The stray light source (detected from 13 µA)
  • The flame sensor, replaced if faulty
  • The tightness of the solenoid valve (oil pump to be replaced)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.