Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
2x

No flame at burner start

Breakdown: the boiler is stopped

On a WL5, WL10 or WL20 oil burner, no flame appeared before the end of the safety time at start-up: oil not arriving, blocked nozzle, ignition, solenoid valve or flame sensor fault. The burner is locked out (red light button) and does not restart by itself; you read this code by counting 2 red flashes after pressing the button for 5 seconds.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 2x?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 2x

The meaning depends on the boiler: find yours below.

2x

No flame, end of the safety time

Breakdown: the boiler is stopped W-FM 05, W-FM 10

The boilers that show this code

What our technician checks

  • The oil supply (air leak), the foot valve and the shut-off valve
  • The pre-filter and the oil pump (seized or faulty)
  • The nozzle, its distance setting and the mixing pressure
  • The ignition electrodes: cleanliness, gap, insulator
  • The ignition cable and the ignition transformer
  • The solenoid valve coil
  • The flame sensor and the burner setting
  • The burner motor and its capacitor

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.