Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
S.33

Waiting: air pressure switch not switched

Blocking: it retries by itself

The air pressure switch does not give the expected signal (on an atmoTEC, the flue gas sensor has detected a fault): the boiler waits before trying again. On the ecoTEC plus VC 486 and 656/5-5, the same code only reports the calibration of the air pressure switch, a normal step.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show S.33?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code S.33

The meaning depends on the boiler: find yours below.

S.33

Air pressure switch calibration

Information: nothing to do VC 486/5-5
S.33

Heat exchanger frost protection active because the pressure capsule has not yet

Blocking: it retries by itself turboVIT combi
S.33

Pressure capsule not engaged

Blocking: it retries by itself VUW /3-5
S.33

Waiting time of the air pressure switch: fault detected by the PTC/TTB sensor

Blocking: it retries by itself VUW /5-5
S.33

Waiting time Air monitoring

Blocking: it retries by itself VCW /5-7

The boilers that show this code

What our technician checks

  • The air pressure switch (air pressure sensor or switch)
  • The PTC and TTB flue gas sensors (atmoTEC)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.