Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.20

Overheat safety device tripped

Breakdown: the boiler is stopped

The overheat safety device has cut the gas: the flow or return sensor measured too high a temperature (lack of water, air, pump), or a loose electrical contact tripped it. It is a safety shutdown: the boiler does not heat until the cause is found; on the atmoVIT and turboVIT, the limiter is unlocked by hand, on the appliance.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.20?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.20

The meaning depends on the boiler: find yours below.

F.020

The overheat cut-off (STB) has cut the gas valve control

Breakdown: the boiler is stopped VCW CS/1-5, VCW CS/1-7
F.20

The safety temperature limiter has tripped

Breakdown: the boiler is stopped VCW /3
F.20

Safety shutdown temp. limiter

Breakdown: the boiler is stopped VC /8-5, VCW /5-3, VCW /5-5, VCW /5-7, VKK /4
F.20

Safety shutdown: temperature limiter

Breakdown: the boiler is stopped VC /4-5, VC 806/5-5, VCC /4, VKK /5
F.20

Safety shutdown: overheat cut-off

Breakdown: the boiler is stopped VC 486/5-5, VUW /4-5, VUW /5-5
F.20

The temperature limiter has tripped Manual reset on the limiter!

Breakdown: the boiler is stopped VK /1-5, turboVIT combi
F.20

Overheat cut-off signal

Breakdown: the boiler is stopped VSC /2, VUW /3-5

The boilers that show this code

What our technician checks

  • The flow and return sensors: loose contact, thermal contact with the pipe
  • The earth connection
  • The ignition cable, connector and electrode (discharge to the casing)
  • Filling, bleeding and tightness of the system
  • The pump and the three-way valve
  • The water pressure and flow sensors
  • The wiring harness and its connectors

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.