Flame lost during operation, relighting failed
Breakdown: the boiler is stopped
The flame went out while the boiler was heating and the relighting attempts failed: for example the gas was cut off for a moment, flue gas recirculating to the air intake, a blocked condensate drain or a poor earth. It goes into fault mode and stops heating; a reset starts a new ignition attempt.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Check that the boiler's gas tap is open.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show F.29?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.29
The meaning depends on the boiler: find yours below.
The ignition attempt after a flame loss during operation failed.
The flame goes out during operation and the following ignition attempts fail
Operation fault Ignition unsuccessful
Fault during operation: re-ignition failure
Ignition and monitoring fault during operation - flame extinguished
Fault during operation The flame goes out during operation and the
The flame goes out during operation and the next ignition attempt fails
Start fault Ignition unsuccessful
The boilers that show this code
What our technician checks
- The gas supply
- The flue: recirculation or blockage
- The condensate drain
- The appliance earth
- The ignition transformer (misfiring)
- The ionisation electrode: contact with the burner, cable
- The air intake pipe
- The gas valve and the air-gas ratio