Flow temperature sensor disconnected
Breakdown: the boiler is stopped
The boiler no longer receives the signal from its flow temperature sensor, which measures the water sent to the heating: the sensor, its cable or a connector is at fault. It is a fault code: the boiler no longer works normally and needs a technician.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.00?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.00
The meaning depends on the boiler: find yours below.
Flow temperature sensor interruption (NTC)
Flow temperature sensor interruption
Flow sensor interruption
Flow temperature sensor open circuit
Heating flow NTC interruption
Flow temperature sensor interruption
Flow temperature sensor open circuit
Flow sensor open circuit
The signal from the flow temperature sensor is interrupted.
The boilers that show this code
What our technician checks
- The flow temperature sensor's connector and cable
- The flow temperature sensor, replaced if needed
- The multi-pin connector on the circuit board
- The wiring harness, for a break
- The circuit board