Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.27

Flame detected with the burner off

Breakdown: the boiler is stopped

The boiler sees a flame signal while the burner is off and the gas valve closed: a leaking gas valve, moisture or a fault on the circuit board, or a fouled electrode. It is a safety shutdown: the boiler switches off and should only be put back into service after a check.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.27?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.27

The meaning depends on the boiler: find yours below.

F.027

A flame signal was detected while the burner is off.

Breakdown: the boiler is stopped VCW CS/1-5, VCW CS/1-7
F.27

Stray light

Breakdown: the boiler is stopped VCW /3
F.27

Safety shutdown Flame simulation

Breakdown: the boiler is stopped VC /8-5, VCW /5-3, VCW /5-5, VCW /5-7, VKK /4
F.27

Safety shutdown: flame simulation

Breakdown: the boiler is stopped VC /4-5, VC 486/5-5, VC 806/5-5, VUW /4-5, VUW /5-5
F.27

The ionisation signal indicates a flame despite the gas valve being closed

Breakdown: the boiler is stopped VK /1-5, turboVIT combi
F.27

"Stray light"

Breakdown: the boiler is stopped VKK /5
F.27

Stray light signal, the ionisation signal indicates a flame despite the gas valve being off

Breakdown: the boiler is stopped VUW /3-5
F.27

Safety shutdown: incorrect flame detection

Breakdown: the boiler is stopped VCC /4
F.27

Stray light: ionisation signal reports flame despite gas valve closed

Breakdown: the boiler is stopped VSC /2

The boilers that show this code

What our technician checks

  • The gas solenoid valve: tightness and operation
  • The circuit board (moisture), replaced if needed
  • The flame monitor
  • The monitoring or ionisation electrode
  • The gas pressure at the upper test point
  • atmoTEC, turboTEC: fouling of the combustion chamber

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.