Flue gas flap or condensate pump fault
Breakdown: the boiler is stopped
An accessory connected to the boiler is blocking the burner: the flue gas flap does not confirm its position, or the condensate pump is faulty or overflowing. This is a fault: the boiler stops and our technician has to find the cause before putting it back into service.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.77?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.77
The meaning depends on the boiler: find yours below.
Burner operation is blocked by a condensate pump or a flue
Condensate pump or feedback signal from the heating accessory module
Flue damper / condensate pump fault
Flue gas damper/condensate pump fault
Accessory error (flue gas damper, condensate pump...)
Flue gas damper/fresh air damper error
Flue damper faulty or the flue damper does not send a correct feedback message
Flue gas damper error
Condensate pump or accessory feedback blocking heating mode
The boilers that show this code
What our technician checks
- The flue gas flap: wiring, feedback switch, correct operation
- The flue gas flap, replaced if faulty
- The condensate pump and its electrical connection, replaced if faulty
- The VR40 accessory cable and the jumper of the 2-of-7 multi-function module
- The contact thermostat jumper