Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.25

Flue gas temperature too high

Breakdown: the boiler is stopped

The flue gas safety device stopped the boiler: the combustion gases are too hot, or the link to the flue gas temperature safety device is broken (cable, connector). On the atmoTEC plus VUW /4-5, F.25 means flue gas escaping from the draught diverter, and on the older ecoTEC VCW /3 a break in the thermal module harness; in every case it is a safety shutdown that needs a technician.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Smell of flue gas in the house? Open doors and windows wide, switch the boiler off and call us.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.25?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.25

The meaning depends on the boiler: find yours below.

F.025

The flue gas temperature is too high.

Breakdown: the boiler is stopped VCW CS/1-5, VCW CS/1-7
F.25

Break in the wiring harness of the compact thermal module

Breakdown: the boiler is stopped VCW /3
F.25

Safety shutdown flue temp. too high

Breakdown: the boiler is stopped VCW /5-3, VCW /5-5, VCW /5-7
F.25

Safety shutdown: flue gas temperature too high

Breakdown: the boiler is stopped VC /4-5, VC 486/5-5, VC 806/5-5
F.25

The flue gas safety temperature limiter has cut out

Breakdown: the boiler is stopped VK /1-5, turboVIT combi
F.25

Flue gas escape detected

Breakdown: the boiler is stopped VUW /4-5
F.25

Safety shutdown: flue gas temperature limiter (accessory for

Breakdown: the boiler is stopped VCC /4
F.25

The flue gas temperature limiter has tripped

Breakdown: the boiler is stopped VSC /2

The boilers that show this code

What our technician checks

  • The wiring harness and its connectors, including the flue gas safety device's
  • The flue gas temperature monitor, replaced if needed
  • The flue: blockage, adverse wind, length
  • The water content, the pump and the internal air vent
  • atmoTEC plus VUW /4-5: the chimney draught and the flue
  • ecoTEC VCW /3: the compact thermal module harness

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.