Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
d1

Return sensor or LSM module fault

Breakdown: the boiler is stopped

On a Eurostar ZWE-4, a Cerasmart or an older Cerapur, the LSM 5 module, which connects the safety device of an underfloor heating, has locked; on a CerapurComfort ZWBR-3, d1 points to a faulty return temperature sensor on the low loss header. It is a fault: the boiler stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show d1?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code d1

The meaning depends on the boiler: find yours below.

d1

The return temperature sensor is faulty

Breakdown: the boiler is stopped Cerapur ZWBR-3
d1

LSM locked

Breakdown: the boiler is stopped Cerapur, Cerasmart, Eurostar ZWE-4

The boilers that show this code

What our technician checks

  • The wiring of the LSM 5 module
  • The underfloor heating limiter, if it has tripped (older Cerapur)
  • The low loss header return sensor and its cable (break, short circuit) (CerapurComfort ZWBR-3)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.