Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
Ad

Hot water cylinder sensor not detected

Breakdown: the boiler is stopped

The boiler does not detect the temperature sensor (NTC) of the hot water cylinder connected to it: the sensor or its cable is at fault, or the sensor was connected to a control module after the boiler had already detected it. It is a fault: the boiler stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show Ad?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code Ad

The meaning depends on the boiler: find yours below.

Ad

Cylinder NTC not detected / The NTC sensor is detected at the Heatronic 3 as…

Breakdown: the boiler is stopped Cerapur ZWB-3, Cerapur ZWBR-3, CerapurSmart
Ad

Cylinder NTC not detected

Breakdown: the boiler is stopped ZWC-3
Ad

Cylinder NTC sensor 1 not detected

Breakdown: the boiler is stopped Cerasmart, Eurostar ZWE-4
Ad

Cylinder NTC 1 not detected

Breakdown: the boiler is stopped Cerapur

The boilers that show this code

What our technician checks

  • The cylinder NTC sensor and its connecting cable
  • Resetting the Heatronic 3 (function 8.E) and IPM 1 or IPM 2 to base settings, then the automatic system configuration on the thermostat (Cerapur ZWB-3, CerapurComfort ZWBR-3, CerapurSmart)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.