Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
CF

Lack of water detected in the system

Breakdown: the boiler is stopped

The boiler's water shortage detector has tripped: there is not enough water left in the heating system, or the detector itself is faulty (CerapurComfort ZWBR-3 and Cerapur TOP 42-3 ZB). It is a fault: the boiler stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the water pressure on the gauge, with the boiler cold: at least 1 bar. Too low? Top up as your installer showed you.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show CF?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code CF

The meaning depends on the boiler: find yours below.

CF

The low water detection has tripped

Breakdown: the boiler is stopped Cerapur ZWB-3, Cerapur ZWBR-3

The boilers that show this code

What our technician checks

  • Topping up the system with heating water
  • The water shortage detector, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.