Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
CE

Heating water pressure too low

Breakdown: the boiler is stopped

On a CerapurComfort ZWBR-3 the water pressure in the heating system is too low (0.5 bar or less): heating water needs topping up. It is a fault: the boiler stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the water pressure on the gauge, with the boiler cold: at least 1 bar. Too low? Top up as your installer showed you.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show CE?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code CE

The meaning depends on the boiler: find yours below.

CE

The operating pressure of the heating system is too low

Breakdown: the boiler is stopped Cerapur ZWBR-3

The boilers that show this code

What our technician checks

  • Topping up the system with heating water

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.