Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
b4

Internal data error

Breakdown: the boiler is stopped

The boiler's electronic control has found an error in its internal data; the technician resets it to its base settings, which also clears the boiler's customised settings. It is a fault: the boiler stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show b4?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code b4

The meaning depends on the boiler: find yours below.

b4

Internal data error

Breakdown: the boiler is stopped Cerapur ZWB-3, Cerapur ZWBR-3

The boilers that show this code

What our technician checks

  • Resetting the Heatronic to its base settings (service function 8.E)
  • The installation's service settings, to be set again afterwards

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.