Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Junkers Fault code Junkers
b1

Coding plug not detected

Breakdown: the boiler is stopped

The boiler does not recognise its coding plug, the small plug that sets the boiler's functions for its model. It is a fault: the boiler stops and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show b1?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code b1

The meaning depends on the boiler: find yours below.

b1

Coding plug not detected

Breakdown: the boiler is stopped Cerapur, Cerapur ZWB-3, Cerapur ZWBR-3, CerapurSmart, Cerasmart, Eurostar ZWE-4, ZWC-3

The boilers that show this code

What our technician checks

  • The coding plug: firmly seated, measured, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.