Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Daikin Fault code Daikin
AH

Hot water tank disinfection not completed

Breakdown: the boiler is stopped

The periodic disinfection of the hot water tank (anti-legionella) did not finish correctly, for example because a lot of hot water was drawn just before or during it, because hot water production was switched off during the disinfection or, on an Altherma 3 H, 3 M or low temperature monobloc, because the tank's booster heater was cut out by its safety thermostat. Daikin lists it among the error codes: it stays on until an installer resets it, and our technician can move the disinfection start time, which is set in the installer settings.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show AH?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code AH

The small number shown beside the code tells which.

AH
00

Tank disinfection function not completed correctly

Breakdown: the boiler is stopped Altherma 3 H, Altherma 3 H HT, Altherma 3 H MT, Altherma 3 M, Altherma 3 R, Altherma LT monobloc, Altherma LT split

What our technician checks

  • The disinfection start time, at least 4 hours after the last expected large hot water draw
  • In schedule only mode, an Eco action programmed 3 hours before the disinfection
  • Tank operation left on during the disinfection
  • The tank booster heater and its safety thermostat

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.