Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.85

Water flow too low, maintenance message

Information: nothing to do

The boiler finds that the water does not circulate enough in the heating circuit and shows a maintenance message; on some models it goes on standby for 10 minutes. It is not a locked fault, but our technician must check the water flow of the system.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Is the water pressure flashing at the same time? Top up the heating water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.85

The meaning depends on the boiler: find yours below.

S.85

Service message "check the circulating water flow"

Information: nothing to do Thema Condens F AS 45/65
S.85

Service message "Insufficient water flow rate, product waiting 10 minutes"

Information: nothing to do Thema Condens AS 48/65

What our technician checks

  • The circulating water flow in the system

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.