Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.59

Water flow too low to start

Information: nothing to do

The boiler receives a heat demand, but the water does not circulate enough in the heating circuit to start the burner: it waits until the minimum flow is reached. It starts by itself as soon as the water circulates enough; if the code stays on, the water pressure and the circulation must be checked.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the water pressure (display or gauge): below 0.8 bar, top up the heating water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.59

The meaning depends on the boiler: find yours below.

S.059

Heat demand present

Information: nothing to do Isotwin Condens CS/1, Thema Condens CS/1
S.59

Waiting time: minimum circulating water flow rate not reached

Information: nothing to do Thema Condens F AS 45/65
S.59

Lack of heating water

Information: nothing to do ThemaClassic C30

What our technician checks

  • The circulation in the heating system
  • The system water pressure

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.