Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bulex Fault code Bulex
F5

Overheating or flue gas sensor fault

Breakdown: the boiler is stopped

On the older ThermoMaster F, ThermoMaster HR TOP, Thema Condens F 24/30, Isotwin and Isomax (F5 without a dot), it is overheating: the water in the boiler got too hot, for example for lack of circulation, and the safety device stopped the boiler. On the ThemaClassic C30 and the ThemaTek C 18/24-LC/1 (F.05), the outer flue gas sensor is disconnected; in both cases the boiler stays off until a technician has been.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Do not reset and do not take anything apart: call us.

Does your boiler show F5?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F5

The meaning depends on the boiler: find yours below.

F.05

NTC sensor open circuit (external flue gas temperature sensor)

Breakdown: the boiler is stopped Thematek C 18/24-LC/1
F.05

PTC sensor open circuit (external flue gas temperature sensor)

Breakdown: the boiler is stopped ThemaClassic C30
F5

Overheating fault

Breakdown: the boiler is stopped Isotwin, Thema Condens F 24/30, Thermomaster F
F5

Manual reset: maximum fault, flow temperature too high

Breakdown: the boiler is stopped Thermomaster HR TOP
F5

Overheating protection

Breakdown: the boiler is stopped Isotwin-Isomax

The boilers that show this code

What our technician checks

  • Older boilers: the pump
  • Older boilers: the flow and return isolating valves being open
  • Older boilers: the radiators open and bled
  • ThermoMaster HR TOP: the flow sensor, its position and the pump cable
  • ThemaClassic C30, ThemaTek: the outer flue gas sensor and its connector
  • ThemaClassic C30, ThemaTek: the appliance reference setting, the harness and the multi-pin connector

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.