Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bulex Fault code Bulex
F16

Flame detection or flow sensor fault

Breakdown: the boiler is stopped

On the older ThermoMaster F, ThermoMaster HR TOP, Thema Condens F 24/30 and Isotwin (F16 without a dot), the boiler does not sense its flame properly (abnormal flame, ionisation electrode disconnected or out of adjustment, poor earth) and goes into safety mode. On the ThemaClassic C30 and the ThemaTek C 18/24-LC/1 (F.16), the water flow sensor is short-circuited; in both cases a technician is needed.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F16?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F16

The meaning depends on the boiler: find yours below.

F.16

Flow sensor short circuit

Breakdown: the boiler is stopped ThemaClassic C30, Thematek C 18/24-LC/1
F16

Flame detection fault

Breakdown: the boiler is stopped Isotwin, Thema Condens F 24/30, Thermomaster F
F16

No flame after 5 seconds, flame present

Breakdown: the boiler is stopped Thermomaster HR TOP

The boilers that show this code

What our technician checks

  • Older boilers: the flame-sensing electrode
  • Older boilers: the main board and the gas valve
  • ThermoMaster F: the CO2 setting
  • ThermoMaster HR TOP: all the earth wiring
  • ThemaClassic C30, ThemaTek: the flow sensor and the wiring harness

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.