Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Bulex Fault code Bulex
F.047

Hot water outlet sensor fault

Breakdown: the boiler is stopped

The sensor that measures the hot water leaving the storage tank or the boiler no longer gives a valid signal: plug loose, cable broken or sensor faulty. This is a fault: the boiler stops and our technician has to find the cause before putting it back into service.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.047?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.047

The meaning depends on the boiler: find yours below.

F.047

The signal of the domestic hot water temperature sensor at the cylinder outlet…

Breakdown: the boiler is stopped Isotwin Condens CS/1, Thema Condens CS/1
F.47

Hot water sensor open circuit

Breakdown: the boiler is stopped ThemaClassic C30

What our technician checks

  • The sensor plug and connector
  • The wiring harness between the circuit board and the sensor
  • The hot water outlet sensor, replaced if faulty

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.