Flame detected while the burner is off
Breakdown: the boiler is stopped
The boiler detects a flame, or a flame signal, at a time when there should be none. For safety, it shuts down.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 6C?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 6C
The small number shown beside the code tells which.
Flame detected although the burner is switched off
After gas shut-off: flame detected
No flame break / post-purge
Flame signal during pre-purge
The boilers that show this code
What our technician checks
- The electrodes: position, dirt, condition; replaced if necessary
- The flue
- Moisture on the circuit board
- The closing of the gas valve at standstill
- The condensate trap
- The burner control unit
- Oil boilers: the first-stage solenoid valve and the flame sensor